If the clock is running fast turn the pendulum nut counterclockwise to decrease the rate.
Pendulum wall clock runs slow.
Fixing a clock that runs too fast can be as easy as turning a screw.
It may take up to two weeks to properly set a clock that runs fast.
If it does not have a little slt that has and s and f on each side then it can not be adjusted go to walmart or a hobby shop and buy a new closck mechanism.
A clock that runs quickly still works fine.
Changing the speed of time keeping is accomplished by moving the pendulum disk up or down.
A pendulum too high causes the clock to run fast.
If the clock is running slow turn the pendulum nut clockwise to increase the rate.
Denser air causes the pendulum to move more slowly.
To speed up the clock tighten the nut turn it toward your right.
Locate the adjustable weight or screw mechanism near the pendulum arm.
Clocks with an interior or exterior pendulum have adjustment screws either on the pendulum or through a hole in the top of the clock.
Pendulum bob with rate adjustment french time and strike.
Can we see the movement.
They are cheap and.
It just needs a simple adjustment.
The movement that s in the clock also does not appear to be a very strung runner rather weak pendulum swing.
Moving a clock to a higher elevation will slow it down as the air is thinner.
Push the bob up to make the clock run faster and push the bob down to make it slower.
The bob will settle lower making the effective length of the pendulum longer.
Too low causes the clock to run slow.
Adjust the bob at the bottom of the pendulum if the clock is running too fast or slow.
You may be able to replace the escape wheel with one that has fewer teeth which will require a longer pendulum.
To slow the grandfather clock down move the pendulum disk down by turning the adjustment nut to the left.
To slow down the clock loosen the adjustment nut turn it toward your left.
The clock will run slower.
Lengthen the pendulum by turning the screw mechanism to the left 1 2 turn.
Shorten the pendulum by turning the screw mechanism to the right 1 2 turn.
Increasing the ambient temperature of a clock will slow it down from the expansion and lengthening of the pendulum unless the pendulum is a compensating type.
