Tighten the hinges that are attached to the wall.
Put shower doors back on.
Place the glass clamp sweep into place on the door s bottom edge and secure it at the door clamp.
Follow the installation instructions provided as details may vary but the following steps are typical.
Old sterling shower doors from abo.
Make slight adjustments and.
Sliding shower doors commonly fall off.
Attach the seal strip to the bottom of the door and cut it to the required length.
Install the inside panel first.
Again using the screwdriver loosen the screw holding the roller and adjust it in the slanted slot it is attached to.
Loosen and remove the hinge screws that are attached to the door and remove the whole shower door.
Take this time to clean your screws with vinegar.
Place end caps on the tops of the wall channels.
Spray the hinges with some wd 40 to help loosen them up.
Raise or lower the doors and test the adjustment.
Lift it up inside the top track and bring it back to vertical as you hang the rollers on.
Attach the door handles and any towel bars.
This is how to repair and put a shower door back on track.
Top rollers adjustment and bottom guide replacement and repair.